TUTO Floor Pillow

Renovate your outer floor cushion

Ah summer, heat, fresh fruits, bathing, holidays and especially idle sessions.

At the same time aesthetic and comfortable, the outer floor cushion is ideal for lounging in the sun, but a tired cushion does not give much envy.

This couture tutorial will allow you to renovate your outer floor cushion, let's go!

Materials

- Sewing machine

- Coil of thread Gütermann

- Outdoor fabric Teflon

- Chalk tailor

- Closing Flash at meter (1m20)

- tape meter

- Special zipper

- Pair of scissors

- Universal Doe Foot

- Sewing pin

Step 1: Cutting Plan

Take the example of an outdoor cushion of 1m20 per 1m20, you will need 3 tissue coupons.

- a coupon of 1m22 by 1m22, you will perform a plot inside at 6 cm from the edge

- another of 1m22 per 1 m

- and a coupon of 1m22 by 0.26 m (26 cm)

Step 2: Assembly

First grab your coupon of 1m22 by 0.26 m (26 cm) and affix it to your coupon of 1m22 per 1 m, adjust the fabric in the angles and draw on chalk several marks 2 cm from the edge. Then mark a mark at 8 cm from the edge facing you, it's on this part that you will perform your first seam.

Start with a breakpoint and sew 2 cm from the edge all along the 8 cm plot previously, then repeat the operation on the other side of your coupons, then sew!

Step 3: Assembly of the zipper

Once, your 2 seams made, spread your assembly and carefully overwrite your seams on the nail to prepare the positioning of the zipper.

You will then position the mesh of the zipper facing the opening at 2 cm from the edge of the fabric. Then pin all along the opening to prepare your sewing assembly.

Once finished, cut the zipper surplus 2 cm from the edge, then enter your special zipper and adjust it to the left on your sewing machine, then enter your assembly and sew to the right of the zipper.

Start by a breakpoint and sew, all along your assembly, once arrived at the end lift the foot, turn your fabric and sew on the width of the closure by performing a stop point, once the right zipper side sewn, switch. The sewing foot on the other side so that you can sew on the left of the zipper.

After making your last stop point, you will then finish the zipper assembly.

Step 4: Assembly of the cover

Enter your previously completed assembly, turn it back and then affix over your coupon of 1m22 per 1m22. Enter your coupon with the plotted marks and return the way that your path is facing the zipper.

Adjust your assembly and your coupon and then carefully pin the angles. Before sewing Remove your special zipper and reposition the base to sewing.

Then sew all around the assembly at 1 cm from the edge, arrived in the angles, lift your sewing foot and turn your fabric before continuing to sew.

Finish with a stoppage and disintegrate the 4 angles, finally open the zipper with the nail to prepare your assembly to return it.

Step 5: Finishes

Return through the zipper opening your assembly by removing well fit the angles by overwhelming them lightly with the fingers.

Then close the opening and turn the assembly over, and then sew around your plot previously 6 cm from the edge.

Position your cushion cover and sew around by following your benchmark.

And here is an outside ground cushion that waits for you!

Video Tuto Floor Pillow Exterior

ID = "Title-Videocusinsol"> Tuto DIY - Renovate your outer floor cushion

ID = "Desc-Videotocusinsol"> Your outer floor cushion stays outside the whole beautiful season and overwhelmed over time?

Our fabrics for outdoor floor cushions

Previous
Next

Related posts